日本SANWA數字萬用表PS8A
- 4000 counts
- Best accuracy 0.7％
- Auto power off(15min.)
- Low power ohm(input voltage 0.4V)at continuity range
日本SANWA數字鉗表DCM2000DR
- Dual display shows voltage/current and its frequency
- EF (Electric Field) detection
- VFD (Variable Frequency Drive) frequency measurement
- Low input impedance voltage measurement capable of attenuating the effects of ghost voltages
- Peak hold (Interval: 5 ms)
- Auto power save (30 min./Cancelable)
日本SANWA數字鉗表DCM400AD
- 4000 counts, 42 segments analog bar graph
- Frequency measurement by clamping and using test lead
- Auto power off (30 min.)
- Low battery power indication
日本SANWA迷你叉形電流表PM-33A
- Lightweight approx.160g
- MAX/MIN value hold
- U-shaped clamp sensor, 7mm thick
- DC/AC current measurable up to 100A
- Auto power off(30min.)
日本SANWA針式萬用表AP33
- Employs test leads woven with nylon. Reduces the possibility of wire damage due to winding and pulling
- The test leads can be winded up and stored
- Battery check function has 2 ranges of 1.5V/9V
- Shock absorbing rubber that is robust against falling
日本SANWA針式萬用表CX506a
- Variety of measurement functions by using 26-contact switch
- Capacitance measurement from 50pF to 2000μF
- High input resistance 50kΩ/V (each range of DC3 to 300V)
- DC polarity switchable
日本SANWA針式萬用表SH-88TR
Features:
■Total 35 wide ranges (22ch sw + additional fuctions)
■Capacitance measurement 1μF〜1F
■LED for continuity check
日本SANWA針式萬用表SP21
- Employs shockproof taut-band meter that is not easily damaged even if dropped
- Zero center meter for ± DCV measurement
- Double protection with fuse and diode to protect the internal circuit from overvoltage
- Battery check
- With a tilt stand that helps to read the meter
日本SANWA針式萬用表YX-361TR
- Employing 24-contact switch and plus alpha function enable you to enjoy a total of 33 functions
- Zero center meter for ± DCV measurement
- With LED for continuity check
- With OUTPUT measurement terminal (series capacitor inserted)
- Battery check
- DC current gain (hFE) of transistor can be measured by using separately available hFE connector
